TenTec
[Top] [All Lists]

Re: [TenTec] O II sweep?

To: tentec@contesting.com
Subject: Re: [TenTec] O II sweep?
From: kc9cdt@aol.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 06 Mar 2009 14:19:21 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Tom,
Easy answers.
1) The width is no longer changeable ( I think it is 36 Khz now, but you can 
tell by taking note of the current freq. then tune to the end of the sweep with 
the tuning cursor, how many Khz? X2 = width of the sweep)

2) Tuning cursor is that blue dach mark at the top of the sweep display. Whe 
you start tuning it moves until you stop. This allows you to tune and pounce on 
a freq. (signal or open spot)

You do already have the new code loaded???don't you???

73,
Lee, KC9CDT








-----Original Message-----
From: TMorton <cx7tt@4email.net>
To: tentec@contesting.com
Sent: Fri, 6 Mar 2009 1:28 pm
Subject: [TenTec] O II sweep?



With downloaded 2.041xl:
Revision history states (in part):

"Enhanced SWEEP function with enlarged display and tuning cursor"

I can not figure out how wide the display is nor what the tuning cursor 
is????

What is the scale of the sweep and can it be adjusted as before?

What is this tuning cursor?

I would like to be able to find open spots in pileups but this display 
confounds me!!

Any suggestions or ideas?

73
Tom
CX7TT
P.S. When would one shift from the RF AGC to AF AGC under "AGC System 
type"? What is the advantage(s)?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>