Be sure Omni is in USB mode as you will be using AFSK and not FSK. Typical
VOX Gain is 50% to 75%, Anti VOX at 5% or less, TX Audio source should not
be BOTH but LINE. Adjust level out of Windows mixer WAVE to about mid fader
position and also VOL CONT on Windows mixer to about mid point. I suspect
that you do not have audio coming out of the laptop.
If you unplug the cables from the laptop you should hear data in the laptop
speaker when you initiate transmit in the software. If you do not, then
something related to the setup of the software or laptop is not correct.
I'm not familiar with MMTTY but there should be a drop down menu that will
allow setting the input level which is the level from the radio to the
computer and there should be a output level which is the level from the
computer to the radio.
73
Bob, K4TAX
----- Original Message -----
From: <k1zn@cox.net>
To: <tentec@Contesting.com>
Sent: Thursday, April 09, 2009 8:20 PM
Subject: [TenTec] Orion RTTY & Soundcard
I am setting up my Orion for Digital direct from Laptop soundcard. Using
TT Aux Cable, and MMTTY, have white and yellow audio cables installed.
Print RTTY FB on Laptop. Can't XMT. in XMT mode, ORION does not enter XMT
mode. Settingss in MENU are: VOX VOX TRIP = 75%; Anti-VOX = 50% (have
tried down to 5%); VOX Hang =0.25sec/ SSB - AUX INPUT GAIN = 72 (have gone
dn to 25); TX AUDIO SOURCE = BOTH; h/w Mic Gain = 0.5db / AUDIO left/right
= main
Any suggestions???
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|