Group...
the part that goes into the pistol does not come with the rebuild kit.
that's ten tec part number 90202
this is the part with the threads that go into the pistol
the shaft that the main tuning knob attaches is part number 90201 and
that part IS included.
looking at the rebuild instruction that came with my last rebuild kit,
part number 90202 is not included with the kit
the instructions say:
"this procedure is written for right hand core drive rods used in most
ten tec pto's. However, models 580, 579 and 2510 use left hand core
drive rods and therefore when performing steps marked with an
asterisk (*) you should reverse the direction in the instructions."
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o
A man with one clock knows what time it is. A man with two clocks is
never sure.
On Apr 22, 2009, at 1:38 PM, Mike Hyder, N4NT wrote:
The tuning knob turns a shaft coupled to a thin, brass shaft by a
vernier
means. The thin shaft extends to the back of the PTO unit. That
shaft has
large threads which pass through and move the piston into and out of the
coil. The 580, 579 and 2510 PTO shafts have left-hand threads while
those
of the other rigs have a right-hand thread. I just dug several out of
my
closet and gave them an eyeball examination. Though my memory is dim,
my
eyesight is OK.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|