Tuesday ,morning.
Regarding the click/clack on the centuron.......I run the relay on the amp from
a seperate switch next to my key (not to the XMTR) and that eliminates the
click/clack.
Al N1MHC
Sunny East Boothbay, ME 04544-0002
==================================
---- Mr Mike <kf8zn@yahoo.com> wrote:
> Don't suppose you have the front panel switch selected to "QSK" vice "PTT"
>
>
> ----------------------------------------------------------------------
>
> Message: 1
> Date: Sun, 28 Jun 2009 18:01:05 EDT
> From: Hamdriver66@aol.com
> Subject: [TenTec] Centaur
> To: tentec@contesting.com
> Message-ID: <d26.3469451d.37794221@aol.com>
> Content-Type: text/plain; charset="US-ASCII"
>
> I have owned a Centaur amp. for some time but have not had time to use it
> often. It has a very loud and distracting relay "clacking" that tries to
> follow each dit and dah at lower speeds but holds in with short drop out
> delay at 35 to 40 wpm. Has anyone had any luck isolating this relay from
> the
> circuit board to prevent acoustically coupling, to soften the noise?
> Would appreciate any constructive input. Thanks. Mike/K4KJC.
> **************Make your summer sizzle with fast and easy recipes for the
> grill. (http://food.aol.com/grilling?ncid=emlcntusfood00000006)
>
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|