Hi Roger:
It's been a while since I owned a MicroHam Keyer but, if I remember
right (and I'm often reminded that I don't) the mike connects to the
MicroKeyer instead of the rig.
If you have not already done so, I'd try 1) eliminating the MicroHam
Keyer from the equation and/or 2) injecting your mike audio into the AUX
port
73, de Mike, K9UW
Amherst, WI
Roger Wise wrote:
I am using the Omni VII 588/AT. Firmware V 1027. Microham keyer.
WriteLog
contest program. Here is the problem. When I send a contest voice
message
from the WriteLog program the audio is perfect. I am monitoring it on a
separate receiver. When I transmit direct using a heil pro set/ plus
everything is distorted. I have broken everything down to just a dummy
load
with same results. I can clean up the distortion by adjusting the TX
Equalizer to a minus 15 db. Used ddifferent mics and same results.I am
wondering if anyone else out there has this same problem. For the life
of
me I don't know when this problem came about. I have run the experiment
on
low power as well as high. I changed grounding cables and even taken
them
off. No effect. Any help out there. I always had great signal reports
about the audio before.
Thanks Roger KI0F
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.707 / Virus Database: 270.14.76/2517 - Release Date:
11/21/09 01:47:00
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec