Re: [TenTec] Distortion SSB Omni VII

["Roger Wise" <jrwise@hbci.com>]

The monitor was off. Thanks anyway
Rog
----- Original Message ----- 
From: "Jeff, W4DD" <w4dd@arrl.net>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Saturday, November 21, 2009 12:13 PM
Subject: Re: [TenTec] Distortion SSB Omni VII


> Make sure your Monitor level is not set too high.  My was and the Heil
> picked up the audio from the earpiece.
>
> Jeff (Orion 1)
>
> -----Original Message-----
> From: Roger Wise [mailto:jrwise@hbci.com]
> Sent: Saturday, November 21, 2009 11:46 AM
> To: tentec@contesting.com
> Subject: [TenTec] Distortion SSB Omni VII
>
> I am using the Omni VII 588/AT.  Firmware V 1027.  Microham keyer. 
> WriteLog
> contest program.  Here is the problem.  When I send a contest voice 
> message
> from the WriteLog program the audio is perfect.  I am monitoring it on a
> separate receiver.  When I transmit direct using a heil pro set/ plus
> everything is distorted.  I have broken everything down to just a dummy 
> load
> with same results.  I can clean up the distortion by adjusting the TX
> Equalizer to a minus 15 db.   Used ddifferent mics and same results.I am
> wondering if anyone else out there has this same problem.  For the life of
> me I don't know when this problem came about.  I have run the experiment 
> on
> low power as well as high.  I changed grounding cables and even taken them
> off.  No effect.  Any help out there.  I always had great signal reports
> about the audio before.
> Thanks Roger KI0F
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec