Hi Ron,
Probably could, but then the speaker would be there as well. The internal
speaker could be used, but in my situation, not real practical since the rig
is newly placed into a raised shelf. Sound would be muffled. I need a
front firing speaker, and may get a TT speaker to replace it. Could still
use the supply, since it is in excellent condition, but I also have a RS35.
I was trying to figure a way to keep the supply and speaker with the rig,
... but on the left side.
Thanks,
David
----- Original Message -----
From: "Ron Zond" <k3miy@csonline.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, November 25, 2009 12:12 PM
Subject: Re: [TenTec] 961 on the left side of rig
David
Can you put the 961 below the rig? Or above it?
Ron
K3MIY
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of David & Chris Drake
Sent: Wednesday, November 25, 2009 9:36 AM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] 961 on the left side of rig
Hi,
Anyone know of a shielding workaround to place a 961 power supply on the
left side of the rig? IE: eliminate hum on the audio.
Using a well shielded heil mic into a 715 processor, and a TT supplied
cable
to rig.
Thanks,
David
Wd9cmd
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|