Yes, I think I read some time back that in some cases you need extra
shielding either in the mic input or the case. My setup is identical to
yours, ....moved it to the left side and hum on the audio. Right
side...none.
David
----- Original Message -----
From: "CSM(r) Gary Huber - AB9M" <glhuber@msn.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, November 25, 2009 12:08 PM
Subject: Re: [TenTec] 961 on the left side of rig
Didn't know it was a problem.. see http://www.csm-gh.com/AB9M-Shack.htm
Been running with this configuration for about twenty years, although its
been with a Paragon before the current Omni VI Plus.
73,
Gary - AB9M
--------------------------------------------------
From: "David & Chris Drake" <drakes@psci.net>
Sent: Wednesday, November 25, 2009 8:35 AM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: [TenTec] 961 on the left side of rig
Hi,
Anyone know of a shielding workaround to place a 961 power supply on the
left side of the rig? IE: eliminate hum on the audio.
Using a well shielded heil mic into a 715 processor, and a TT supplied
cable to rig.
Thanks,
David
Wd9cmd
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|