Well now,
Sam or Paul,
Please let me know the places you replaced the caps, and the values of them
etc. my address is k2lot@roadrunner.com Thank you
>
> have
On Jan 18, 2010, at 5:34 PM, Sam wrote:
> I also the Omni VI+ and what i did to widen the SSB RX response was
> to install the INRAD SSB mod which consists of some capacitors that
> replace existing caps on the board. What it does is to move the notch
> filter out of the passband at it's minimum setting as there is no way to
> turn the notch filter off. It also eliminated the high frequency roll
> off and the pass band ripple. It worked so well that i repaced the
> stock 2.8 SSB filters that come in the radio, including the Y2 filter,
> with 2.1 INRAD filters and the RX is now perfect. I also have the SSB
> roofing filter and various other filters, but that's another story.
>
>
> Good luck and 73.
>
> Paul (N6MYA)
>
>
>
>
>
>> I have a omni VI+ coming and it is hard to wait for the delivery....
>> I would like to know where I may get the 2.8 kc filters. I have
>> heard
>> that the SSB is a little narrow and I would like it a little wider
>> than 2.4 kc
>> in one or two in the filter positions ..... any comments greatly app.
>> Thanks John K2lot
>> _______________________________________
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|