[TenTec] Manuals and serial control of Delta II

[Alan Sewell N5NA <alan.n5na@gmail.com>]

I suspect the Delta II and Argo II use Icom commands.  There is info 
from 1998 at <http://www.tentecwiki.org/doku.php?id=536addr> for setting 
the transceiver address.
I think you just need an Icom CI-V interface to plug into the 1/8" jack 
in the back of the rig.  Set your software for one of the older Icom 
rigs and see what happens.
73,

Alan  N5NA


> Date: Fri, 22 Jan 2010 13:32:45 -0500
> From: "Kris Merschrod" <Kris@merschrod.net>
> Subject: [TenTec] Manuals and serial control of Delta II
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Message-ID: <C3B010640F094CE1A9F0C467458A4C6D@Staples0258PC>
> Content-Type: text/plain; format=flowed; charset=iso-8859-1;
>         reply-type=original
>
> Stephen,
>
> Thank you for the tip, as much as I looked around the TenTec site I did not 
> come to that section - now it is in may Radio Favorites tab.
> I was probably wrong the other day on computer control of the Delta II and 
> Argo, but I can't figure that out and have not seen software for the serial 
> port -
> Kris (KA2OIG)
> Merschrod
> 123 Warren Road
> Ithaca, NY 14850
> www.merschrod.net
> ----- Original Message ----- 
> From: "Stephen Cannon" <sugar_bears_home@yahoo.com>
> To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
> Sent: Tuesday, January 19, 2010 8:55 AM
> Subject: Re: [TenTec] Rig Control
>
>
>