On Mon, 25 Jan 2010 19:17:00 -0600, Duane Calvin wrote:
>The OMNI VI and VI+ both did computer control
I used my Omni V.9 extensively with Writelog using a standard
serial cable. Only pins 2, 3, and common on a DB9 are needed
for computer control. I used pin 4 and common to send CW.
Worked VERY well. You do NOT need a separate serial cable for
CW. You DO need the same simple NPN inverter that you need for
any other rig.
I would expect that it would also work well with N1MM and HRD.
You have to tell the software that it's a different transceiver
(Kenwood or ICOM, don't recall which). N4PY can tell you -- as
I recall, the full control compatibility was provided by his
chip mod (that made it a V.9).
73,
Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|