TenTec
[Top] [All Lists]

[TenTec] Omni VII Heading Back to TT Tomorrow-RX Audio Hum Problem Persi

To: Ten Tec Reflector <tentec@contesting.com>
Subject: [TenTec] Omni VII Heading Back to TT Tomorrow-RX Audio Hum Problem Persists
From: David and Dianne on Comcast <dhhdeh@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 07 Feb 2010 17:27:05 -0500
List-post: <mailto:tentec@contesting.com>
Hi Everyone,

Just a quick FYI with a future follow-up when problems are resolved.

Despite many suggestions of performing a master reset, tightening board screws and re-seating connectors throughout my 18 month old Omni VII, the audio hum problem persists.

Upon a cold start the audio in the speakers has a distinct a/c hum that is multiplies 10 fold when the tune button is pushed with or with the tuner in line, loading into a dummy load. It's deafening.

Then about 30-45 minutes later its completely cleared up and gone only to return with the next cold start.

Some component, somewhere, perhaps in the audio circuit, is temperature sensitive and getting ready to fail outright.

Back to TT it goes tomorrow.

Needless to say I am a bit disappointed. Over many years of owning new TT gear, I have yet to own one that has not experienced a hardware failure of some kind fairly early on. I'm hoping that UPS has recovered from the holiday rush and has the 'A' team working this week.

Offering this posting as info for the knowledge base and to see if anyone else has experienced anything similar.

73 de N1LQ-Dave


<Prev in Thread] Current Thread [Next in Thread>