Re: [TenTec] Orion 2 output power

[<wow_chf@hotmail.com>]

I would have to go to the trouble of reading the schematic, but I guess I 
assumed that it is the maximum permissible collector current set.  This 
would be how Ten Tec protects the final transistors.
When I have a chance I will look and see for sure.  I really can't say for 
sure without looking at the roadmap.
Mike
W2AJI

--------------------------------------------------
From: "Ron Castro" <ronc@sonic.net>
Sent: Sunday, February 07, 2010 7:06 PM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion 2 output power

> Just out of curiosity, what does the "IC" pot do?
>
>            Ron Castro
>  Chief Technical Officer
>     Results Radio, LLC
>                N6IE
>       www.N6IE.com
>
> ----- Original Message ----- 
> From: "Mike Schatzberg " <wow_chf@hotmail.com>
> To: "Discussion of Ten-Tec Equipment " <tentec@contesting.com>
> Sent: Sunday, February 07, 2010 3:03 PM
> Subject: Re: [TenTec] Orion 2 output power
>
>
> > The ALC set does not calibrate the meter, it will adjust the maximum
> > output. Pse see the procedure on my website. Mike W2AJI
> >
> >
> > -----Original Message-----
> > From: shristov
> > Sent: 2/7/2010 9:48:11 PM
> > To: Discussion of Ten-Tec Equipment
> > Cc: 'Discussion of Ten-Tec Equipment'
> > Subject: Re: [TenTec] Orion 2 output power
> >
> >
> > Adjust the ALC SET pot (R179) on the A5 IF Board, beneath the speaker.
> >
> >
> > 73,
> >
> > Sinisa  YT1NT, VE3EA
> >
> >
> >
> > ----- Originalna poruka -----
> > Pošiljalac: Steve Narducci <steve@ndwave.com>
> > Datum: Nedelja, Februar 7, 2010 22:07
> > Tema: [TenTec] Orion 2 output power
> > Primalac: 'Discussion of Ten-Tec Equipment' <tentec@contesting.com>
> >
> > > I picked up a second hand Orion 2 six months ago.
> > > The output power is off on its reading as I am sure the previous owner
> > > played with this.
> > > While reading 65 watts it really puts out 100W.
> > > It will go way above 100W if I run her up.
> > > However, I really want to bring it back into specs.
> > > Anyone have a how-to guide on doing that?
> > >
> > > Thanks in advanced!
> > >
> > > Steve W9SN
> > >
> > >
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec