| To: | Ten-Tec List <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] QRPp experiment on the Omni VI |
| From: | Jim Goudie <jagoudie@comcast.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 10 Mar 2010 15:30:31 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Forwarded from K1FK: Jim, I measured the output with a calibrated spectrum analyzer (just back from NIST cert. cal lab). The meaured output into 50 Ohm load is +10dBm or 10 mW. I'm not subscribed to the reflector but feel free to post this if you wish. 73, Dave, K1FK Fort Kent, ME |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Older Argonauts, geoffrey mendelson |
|---|---|
| Next by Date: | Re: [TenTec] QRPp experiment on the Omni VI, Bill Rowlett |
| Previous by Thread: | Re: [TenTec] QRPp experiment on the Omni VI, DAVID HELLER |
| Next by Thread: | [TenTec] Paragon Problem, KA6UUP |
| Indexes: | [Date] [Thread] [Top] [All Lists] |