I never noticed the pull-in voltage. I had that link bookmarked in my
pegasus files as a replacement. I think it came from this list. I no
longer have my 550, but maybe someone out there is adventurous and could do
a voltage check.
There is a 5v version listed, apparently also made of unobtainium.
http://www.newark.com/panasonic-ew/als2b05tw/miniature-power-relay/dp/45M7085
n4zsa
----- Original Message -----
From: "Dr. Gerald N. Johnson" <geraldj@weather.net>
To: <tentec@contesting.com>
Sent: Monday, March 29, 2010 2:36 PM
Subject: Re: [TenTec] Pegasus 550
> The part number indicates a 12 volt coil.
>
> 73, Jerry, K0CQ
>
> On 3/29/2010 12:21 PM, Denton wrote:
>> I used to have a Peggy, and one of the relays on the band pass filter
>> board
>> failed...if I remember right, the relay coils for both input and output
>> of
>> the filter are wired in series...I replaced mine with two new relays that
>> had 6 volt coils.
>> ----- Original Message -----
>> From: "phil g"<trapperpg@earthlink.net>
>> To: "Discussion of Ten-Tec Equipment"<tentec@contesting.com>
>> Sent: Monday, March 29, 2010 11:04 AM
>> Subject: Re: [TenTec] Pegasus 550
>>
>>
>>> Here is a link to the relay. Also avail. from Ten Tec.
>>> http://www.newark.com/jsp/search/productdetail.jsp?SKU=45M7086
>>>
>>> Fairly straight forward to replace. Unsolder the old, solder in the
>>> new.
>>>
>>> n4zsa
>>> ----- Original Message -----
>>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|