Plug it in. The LEDs on the front panel tell you which VFO is doing what.
Mode 6 is cool, the two vfos are BOTH on for RX, allowing you to listen to
two things at the same time.
Hope your dial cord is still good...BTW, dial restringing is not in the 243
manual. And if you want one, email me, as I have spare one, downstairs in my
flooding basement (otherwise I'd have answered directly...)
The basic Shure desk mic (450 series?) works for me.
David Goncalves
On Mon, Mar 29, 2010 at 9:00 PM, Dave <w8drk@woh.rr.com> wrote:
> Hi, Gang:
> I just purchased an Omni D, series B, and also received a model 243 VFO
> with it. Unfortunately, there were no manuals for either piece. I found, and
> downloaded, the manual for the Omni D on the TenTec website, but there is
> nothing listed for the 243. I was just wondering if someone could tell me
> what the 6 positions of the lower right hand switch are? I think they are
> various setups for the vfo (main VFO, outboard vfo, split, etc.), but would
> like to know the actual function of each position. If the rig checks out OK,
> (and so far it is checking out very well for a 30 year old rig!) I will
> probably order a manual for it at a later date.
> Also, on a side note, I was wondering what microphones you have had good
> results with on the Omni D?
> 73: Dave
> W8DRK
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
--
David Goncalves
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|