| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni-D (Ser B) - Popping on some 10m bands |
| From: | "W8BVH" <w8bvh@sbcglobal.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 6 Apr 2010 15:58:21 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
Greetings to the net:I have a stock Corsair II that has been idle for about 4 months due to some family health issues. I turned it on yesterday and found the display only reads 9.0000 or 91.0000 no matter what band you select. I know that there was a discussion about this some time ago but was unable to find the answer in the archives. Can someone give me a hint?? I opened the top and removed the filters and lossened up the screws on all of the boards that I could reach from the top and re-tightened them. I removed all of the plugs on the boards, one at a time, and re-seated them. All to no avail. Thanks to all in advance for your patience and the bandwidth. Oh, I'm using the 961 power supply. Best regards, Ralph Howes W8BVH |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Omni-D (Ser B) - Popping on some 10m bands, Dr. Gerald N. Johnson |
|---|---|
| Next by Date: | Re: [TenTec] Omni-D (Ser B) - Popping on some 10m bands, David Goncalves |
| Previous by Thread: | Re: [TenTec] Omni-D (Ser B) - Popping on some 10m bands, Dr. Gerald N. Johnson |
| Next by Thread: | Re: [TenTec] Omni-D (Ser B) - Popping on some 10m bands, David Goncalves |
| Indexes: | [Date] [Thread] [Top] [All Lists] |