I'm not going to look a gift horse in the mouth, my VOX trip is now up to
100%.
John de VK2XGJ
Money talks, Chocolate sings!
----- Original Message -----
From: "Chris Hinson" <chinson1@mindspring.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, April 11, 2010 10:48 AM
Subject: [TenTec] Red Sweep Screen gone
>I accidently found out how to keep my Orion 2 sweep screen from turning red
>with the newest software.
> This last January while dusting off the radio I turned on the VOX. I did
> not realize this until I spoke to my wife and the relay in the amp
> clicked. I ID and then turned the VOX off.
> To keep from doing this again I turned the VOX trip rate up to 100%.
> After two weeks I realized the red sweep that was a everyday problem was
> gone.
> I waited another week and turned the trip rate back down to 10% and with
> in two hours the screen turned red.
> I turned the trip level back up and no red screen for three months until
> today when I turned the trip level back down to 10%.
> Can someone tell me how the VOX circuit effects the sweep or is this
> something that only works with my O2.
> Thanks in advance
> Chris K4OSK
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|