TenTec
[Top] [All Lists]

Re: [TenTec] Orion II v 2.042A: Not Ready for Prime Time!

To: "Ron Castro" <ronc@sonic.net>, "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion II v 2.042A: Not Ready for Prime Time!
From: "Ron Castro" <ronc@sonic.net>
Reply-to: Ron Castro <ronc@sonic.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 13 Apr 2010 18:50:03 -0700
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Addendum to my post:  on problem #1, I'm referring to the RX audio.  TX 
audio (other than more drive needed and processor problem) still sounds 
broadcast quality.

            Ron   N6IE
       www.N6IE.com

----- Original Message ----- 
From: "Ron Castro" <ronc@sonic.net>
To: <tentec@contesting.com>
Sent: Tuesday, April 13, 2010 6:41 PM
Subject: [TenTec] Orion II v 2.042A: Not Ready for Prime Time!


> Here are a list of problems I found right off with the v. 2.042A, even 
> after doing a battery reset and two master resets and memory clear:
>  1.. Very noticeable distortion on all audio.  Sounds like overdrive in IF 
> or DSP section.
>  2.. AGC hang in AF AGC.  S-meter goes up and never comes down!  At same 
> time, RF gain goes down and does not come back up.  If you manually turn 
> the RF Gain all the way to 0, then back up to 100, the radio is 
> essentially muted.  This will not happen if the "AGC Hang" setting is 0, 
> but then distortion is really bad.
>  3.. NR does not work in AF AGC mode.  Does seem to work well in RF AGC 
> mode.
>  4.. Much more audio drive needed on AUX input for SSB.  It looks like 
> about 10 dB more.
>  5.. AM carrier= 1.25 Watts max!  That's at 100% PWR setting.
>  6.. FM carrier= 6.4 Watts max.
>  7.. SSB Speech Processor gives only around 50 Watts max peak output.  You 
> can get it up to 100 Watts when you crank it to "way beyond reasonable 
> distortion".
>  8.. Could not find any sort of S-Meter calibration
> Here are the good points so far:
>  1.. Side tone is louder and spot level is too.
>  2.. Waterfall display is much improved.
>  3.. Difference in frequency between Main and Sub improved, but still not 
> "phase locked".  I detect about 0.1 Hz differential which should make it 
> fine for true diversity antenna work.
>  4.. In RF AGC mode, the NR really does seem improved, although it's hard 
> to tell with the audio distortion mentioned above.
> So that's the good, the bad and the ugly of it!  I'm QSYing back to v. 
> 2.039d, the last one that worked right...
>
>            Ron  N6IE
>       www.N6IE.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>