Bill...
You can locate the low-value that is currently the blocking capacitor in
series with the RIT varactor (voltage variable capacitor) and, say, double
its value.
It's probably around 5 to 10 pf. and if you double it and then re-center the
RIT calibration, you will obtain approximately twice the change through the
same voltage swing.
Of course in doing this, you will quicken the response of the RIT control,
covering more cycles per degree of rotation.
Phil C. Sr.
k4dpk
----- Original Message -----
From: "Bill Acito W1PA" <w1pa@hotmail.com>
To: <tentec@contesting.com>
Sent: Thursday, April 22, 2010 4:47 PM
Subject: Re: [TenTec] Extend RIT on Argosy or Scout?
Can this be done on either of these rigs? (at least +/- 5 KHz, 7 would be
better)
If so, how?
Thanks. Would really like the opportunity to work "split", at least for
the
guys
working "up 5, up 5". i.e. set the PTO to the TX, and then the RIT/Offset
back
to the DX freq.
Bill W1PA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|