I have downloaded and installed V2.043B. Seems to be playing very well.
The NR is better than before.
For future fixes, I would like to see some work done on the sweep display.
When the sweep bandwidth is narrow the displayed signals look like big
blocks and do not represent the actual signals very well. The display at
narrow sweep bandwidths the display is not very useful.
Thanks and 73... Bill K3WA
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
4. Re: Orion 2 Firmware 2.043B Released (Philip C. Anderson)
> Date: Thu, 3 Jun 2010 10:19:34 -0400
> From: jhenry@tentec.com
> To: tentec@contesting.com
> Subject: [TenTec] Orion 2 Firmware 2.043B Released
>
> Based on customer inputs we have just released new Orion 2 Firmware.
> Version 2.043B. Extensive testing was done with several beta testers
> to ensure that this release is valuable and reliable. Many problems
> were resolved, and some features were re-written. So there may be
> instances where some features don't operate or perform exactly as you
> are use to in the previous released firmware. For example, the Noise
> Reduction algorithm has been redone. Under some conditions, a NR level
> of 1 may produce what appears to be pops in the audio. This is
> actually still some of the noise getting through. But as you increase
> the aggressiveness of the NR, the pops will go away and so will the
> noise floor. Different types of noise and different signal strengths
> of the recovered audio will warrant different aggressiveness levels.
> Thank you for your patience, and as always comments are welcome, just
> send an email to ditsnbits@tentec.com.
>
> Thanks
> John Henry, KI4JPL
> TenTec Engineering
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|