On a related note, I will submit the Commander command sequences for OMNI-VII
TX/RX VFO mode splits later this evening.
By using a different mode in each VFO, different bandwidths may be used for the
DX and the pile.
73,
Gary - AB9M
From: Dave AA6YQ
Sent: Saturday, August 07, 2010 12:01 PM
To: dxlab@yahoogroups.com
Subject: RE: [dxlab] HRD & DXLab
>>>AA6YQ comments below
-----Original Message-----
From: dxlab@yahoogroups.com [mailto:dxlab@yahoogroups.com]On Behalf Of
Jerry Keller (K3BZ)
Sent: Saturday, August 07, 2010 12:57 PM
To: (REFLECTOR) DXLAB
Subject: [dxlab] HRD & DXLab
I keep hearing about HRD and thought I'd try it with DXLab, just for fun.
Couple questions:
Has the new HRD matured enough now for use with DXLab? (with HRD Bridge)
>>>As far as I know, HRD still can't be directed to set VFO B or
enable/disable split, so if you double-click a Spot Database Entry for a
station operating split, you'll have to manually setup your transceiver for
split frequency operation.
If I install HRD Bridge and HRD, and don't like it, is it easy to reverse
the process and get back where I was?
>>>Yes -- you'd simply terminate HRD and the HRD bridge, and run Commander
instead.
73,
Dave, AA6YQ
__._,_.___
Reply to sender | Reply to group | Reply via web post | Start a New Topic
Messages in this topic (2)
Recent Activity: a.. New Members 6 a.. New Files 2
Visit Your Group
MARKETPLACE
Stay on top of your group activity without leaving the page you're on - Get the
Yahoo! Toolbar now.
--------------------------------------------------------------------------------
Get great advice about dogs and cats. Visit the Dog & Cat Answers Center.
--------------------------------------------------------------------------------
Hobbies & Activities Zone: Find others who share your passions! Explore new
interests.
Switch to: Text-Only, Daily Digest . Unsubscribe . Terms of Use.
__,_._,___
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|