Also... if you can wiggle the bandswitch and restore the function, it
probably needs cleaning.
Mike N4NT
----- Original Message -----
From: "JOSEPH DAVIS" <iloveantennas@dishmail.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, October 29, 2010 11:16 AM
Subject: Re: [TenTec] question on TT- 546
Thanks for ur answer,will try this . jjdavis
On Thu, Oct 28, 2010 at 11:03 AM, Rick - NJ0IP / DJ0IP
<Rick@dj0ip.de>wrote:
There's something wrong in the local oscillator.
Check around the area where the crystal is for 80m and resolder the
connections.
73
Rick
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]
On Behalf Of JOSEPH DAVIS
Sent: Thursday, October 28, 2010 8:58 AM
To: TenTec@contesting.com
Subject: [TenTec] question on TT- 546
On 80 meters occasionally frequency output goes to 1.000 mhz and receiver
goes dead. After a while will go on again. Other freq. ranges OK. Any
one
have any ideal? Thanks jjdavis
|