TenTec
[Top] [All Lists]

Re: [TenTec] (no subject)

To: tentec@contesting.com
Subject: Re: [TenTec] (no subject)
From: "Dr. Gerald N. Johnson" <geraldj@weather.net>
Reply-to: geraldj@weather.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 11 Nov 2010 12:30:39 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
 From the on line Corsair II manual, pin 1 is audio, pin 2 is ground, 
pin 3 is PTT and pin 4 is +v for electret power.

So white goes to 1, 2 gets shield, I'm not sure about black and red. But 
with a model number for the TenTec microphone, there's probably a manual 
on line describing their function.

73, Jerry, K0CQ
On 11/11/2010 11:22 AM, Jim Huicks wrote:
> Thanks, I also need the wiring on a Corsair 2, I have a Ten Tec base mic, 
> wires sheild with white wire, and a red and a black if someone could tell me 
> were they go on the mic connector. Thanks Jim
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>