TenTec
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [TenTec] 4229 Tuner Balun Replacement?

from [Richards] [Permanent Link][Original]
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] 4229 Tuner Balun Replacement?
From: Richards <jruing@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 15 Nov 2010 12:11:22 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com> 
Holy Cow.... I meandered around that web site and just fell in love with 
all that TenTec gear on a single desk...       MMMmm.......


============================== James- K8JHR  =======================

On 11/15/2010 9:57 AM, Steve Hunt wrote:
> There are some CM choke impedance measurements here:
> http://www.karinya.net/g3txq/chokes/
>

====================================================================
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: [TenTec] 4229 Tuner Balun Replacement?, Steve Hunt
Next by Date:  Re: [TenTec] 4229 Tuner Balun Replacement?, Don Jones
Previous by Thread:  Re: [TenTec] 4229 Tuner Balun Replacement?, Steve Hunt
Next by Thread:  Re: [TenTec] 4229 Tuner Balun Replacement?, Don Jones
Indexes:  [Date] [Thread] [Top] [All Lists]