I didn't know about Dan's but they have an audio CW filter kit:
http://www.danscloseoutsandspecialdeals.com/kitcloseouts.html
http://www.danssmallpartsandkits.net/
----- Original Message -----
From: "Mike Hyder -N4NT-" <Mike_N4NT@charter.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, December 14, 2010 11:09 AM
Subject: Re: [TenTec] Replacment cw filter
> Having used several of the "older" Ten-Tec rigs, my feeling is that 98% of
> the time I am much happier using an audio filter in the rig than a crystal
> filter. The audio CW filter makes them sound like "real Ten-Tecs" to my
> ears.
>
> If you choose to fabricate an audio filter, it is important to put it into
> the circuit as the rig is originally designed. The AGC voltage in the
> rigs
> is generated from audio. If the filter does not appear before the AGC
> sampling point, signals outside the passband can still "pump-up" the AGC
> voltage. This is true of external audio filters, too.
>
> 73, Mike N4NT
>
> ----- Original Message -----
> From: "Curt" <rhulett1@consolidated.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Cc: "Marty Hartwell" <mhartwe@gmail.com>
> Sent: Tuesday, December 14, 2010 10:37 AM
> Subject: Re: [TenTec] Replacment cw filter
>
>
>> Hello Marty,
>>
>> Having the same problem you did trying to find a 245 for a 544 I bought,
>> used the 245 from my 540 as a pattern. All the components are still
>> available, so had a PCB fabricated using my 245 as a pattern. Did a less
>> than perfect job of duplication, had to redrill holes for the 7 vector
>> pins
>> used to connect the board to the rig.
>> A lot of time and trouble for what might just as easily be accomplished
>> using an outboard audio filter, just to prove to myself that could do it.
>>
>> Anyway, it works perfectly, just same as the 245 in my 540. It isn't
>> very
>> complex, just two dual op-amps and some resistors and caps. Somewhere I
>> have the TT documentation, pictures, parts list, schematic, pattern of
>> the
>> PCB.
>>
>> Building one on vector board is certainly feasible, and maybe easier than
>> dealing with a PCB.
>>
>> GL & 73, Curt
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|