Miniature electrolytics are ripe for replacement due to old age. Go for
low ESR high temperature rated for the best performance and long life.
Don't forget those on the display board. I doubt Tentec would consider
shotgun replacement of electrolytics to be practical at their costs of
labor.
As for alignment, if it hears antenna noise louder than its noise on all
bands and puts out rated power everywhere, I don't think it needs
alignment. I've never found alignment a better procedure than proper
signal tracing for troubleshooting and problems. Indeed alignment can
introduce more problems from adjusting parts that didn't need adjusting
but were frozen with age. Split cores come to mind, NEVER use a metal
allen wrench on a core of a coil. It gets a thousand times harder to
turn after its split by the metal wrench. Use only plastic alignment
tools that fit the cores. Alignment was needed more in tube radios where
tube replacement was commonly required and the tube capacitances were a
significant portion of the resonann circuit tuning C. Then a different
tube with 1 pf different C required alignment. We aren't swapping
transistors that much, though when a transistor is replaced and its
connected to tuned circuits, alignment of that stage is most appropriate.
73, Jerry, K0CQ
On 1/1/2011 12:21 PM, Andrew Moore wrote:
> I've got the Corsair II on the bench for a PTO cleaning or possible rebuild.
>
> While I'm at it, I'm considering
>
> a) complete realignment
>
> b) replace any components that may go out of spec due to age
> (would electrolytic caps fall into that category?)
>
> I realize there's also a "don't fix it if it ain't broke" angle but I'm
> leaning towards realignment/replacement.
>
> Seeking opinions on a) and b) above.
>
> I don't have a scope, but do have a multimeter, wideband noise generator,
> and test oscillator for 20/40/80 meters. Better off sending it to Ten-Tec
> (if they still do this), or do it myself?
>
> Who's "been there done that?"
>
> Thanks,
> --Andrew, NV1B
> ..
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|