TenTec
[Top] [All Lists]

Re: [TenTec] Was I bad???

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Was I bad???
From: Michael Goins <wmgoins@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 24 Jan 2011 10:38:31 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Phil/Andy,

It should work just fine as it is essentially the same circuitry as the
older 234 that was analog. I've used both and they work quite well at
increasing average talk power.

Mike, k5wmg
Pipe Creek, Texas
Green cars, slow boats, big dogs, old trucks, little radios, and summers off
to write



On Mon, Jan 24, 2011 at 10:34 AM, Ron Notarius W3WN <wn3vaw@verizon.net>wrote:

> Tell you what... buy me a 715, and I'll let you know how it works on my
> Corsair.  Just give me a month or two.
>
> I don't think it will do much on my PM-2B though.  Just a hunch.
>
> 73
>
>
> Jan 24, 2011 11:30:15 AM, tentec@contesting.com wrote:
>
>
> Good morning folks,
> I have not seen any replies to my posts, the last one asking if any one has
> tried the TT 715 speech processor with older TT radios.
>
> If I did something wrong or offended any one, I apologize.
>
> Phil (Andy) W3LI
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>