TenTec
[Top] [All Lists]

Re: [TenTec] Hallicrafters SX28 - was CorsairII notch potentiometer

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Hallicrafters SX28 - was CorsairII notch potentiometer
From: "Ronnie" <n1udi@att.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 15 Feb 2011 00:54:16 -0500
List-post: <mailto:tentec@contesting.com>
Hello Ralph

In ref: to your msg about the SX-28. I have friend that might have interest in the radio. First is it still available ? Second can you supply jpgs of the radio? Third how bad off is it? Sense he is vision impaired I would have to be the one to work on it for him to get it back up to specs. Advise.
Regards, Rock

----- Original Message ----- From: "Ralph Smith" <rr1935@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, February 12, 2011 5:00 PM
Subject: Re: [TenTec] Hallicrafters SX28 - was CorsairII notch potentiometer


I have a SX28 sitting on the bench that I recieved from another ham when I liquidated his radios. It needs a lot of tender loving care and is available. Has not worked in years.

Ralph W8HG
----- Original Message ----- From: Steve Hunt
 To: Discussion of Ten-Tec Equipment
 Cc: Richards
 Sent: Saturday, February 12, 2011 4:32 PM
Subject: Re: [TenTec] Hallicrafters SX28 - was CorsairII notch potentiometer


 Good question - but I'm not the owner. I'm simply checking it out for
 him. He owned an SX28 when he was a teenager in the 1960s - I think this
 is a "nostalgia trip" for him rather than a restoration project :)

 73,
 Steve G3TXQ



 On 12/02/2011 21:01, Richards wrote:
 > Would it adversely affect its value if one painted the cabinet (not the
 > face, as it appears it would clean up rather well)  - but it would be
 > nice to eliminate   that bit of rust lurking and peering out from under
 > the top panel.
 >
> I am not being critical... it is a fine specimen. I do know that some
 > restorations are considered poor form by serious collectors, while
 > others are not.
 >
 > So... would a repaint of the cabinet be appropriate for this type of
 > rig?  (Assume the final result is as close to the original look as
 > possible.)
 >
 > Happy Trails.
 > =======================  Richards / K8JHR  =========================
 _______________________________________________
 TenTec mailing list
 TenTec@contesting.com
 http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


<Prev in Thread] Current Thread [Next in Thread>