John,
A BIG thank you for your efforts.
At first blush everything seems to be working great. Receive audio quality and
NR are much inproved. Also I like the looks of the scan. It now seems to have
just one sweep width but the display is much improved.
73, Bill - K6WLM
--- On Thu, 2/17/11, Henry, John <jhenry@tentec.com> wrote:
From: Henry, John <jhenry@tentec.com>
Subject: [TenTec] Orion 565 Firmware Released
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Date: Thursday, February 17, 2011, 11:12 AM
Version 2.064x11 was just released to the TenTec website.
http://www.tentec.com/index.php?id=204#down
Modifications include:
Reduced "Receiver blow-by" in sub and main rx
Incorporated NR from the Orion II
Increased 60m band size
Improved Step selection handling
Improved AN/NB/NR Crashing
Added PBT to band registers
Sweep Display recalibration
Modified NR control range
Improved sub receiver AM mute problem
Improved rear panel band info update bug
Resolved serial TUNER command
Resolved FSK/CW tone interaction
Resolved raspy CW tone interaction with SSB modes in sub Rx
Resolved subrx key click when main rx in CW
Resolved AM vs SSB audio crashing
Note: When transitioning to/from this version with previous versions,
it is highly advised that the user perform a master reset and a ram
clear.
Utilized Windows 7 64-bit compatible installer
Utilized Windows 7 64-bit compatible update.exe
As stated, a Master Reset and a RAM Clear are required after
installing this update on your Orion 565.
Special thanks to the tireless beta testers. Without them, this would
not have been completed.
73, KI4JPL
Thanks,
John Henry
TenTec Engineering
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|