TenTec
[Top] [All Lists]

Re: [TenTec] Orion II

To: tentec@contesting.com
Subject: Re: [TenTec] Orion II
From: John Molenda <cdistflatfoot@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 18 Feb 2011 17:53:48 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On 2/18/2011 5:27 PM, ROD wrote:Well I must say that I did enjoy the 
waterfall display !  However I fear that we will be waiting for some 
time to see a update to the Orion II per John's last .  John Molenda kb2huk
> I DID NOT LIKE THE WATER FALL AS SOON  AS I SAW IT I WENT BACK TO THE OLD
> UPDATE. AND I AM NOT THE ONLY ONE.
>
> -----Original Message-----
> From: Rsoifer@aol.com
> Sent: Friday, February 18, 2011 5:00 PM
> To: tentec@contesting.com
> Cc: jhenry@tentec.com
> Subject: [TenTec] Orion II
>
> Hi John,
>
> I hear you about  the 566.  V2.044A is very good, but please  don't forget
> about the waterfall display.  I'm not at all convinced I would  want a high
> speed sweep board, but I did like the old waterfall.
>
> 73 Ray W2RS
>
>
>
> In a message dated 2/18/2011 9:47:39 P.M. GMT Standard Time,
> jhenry@tentec.com writes:
>
> Hi  Bill,
>
> It is on the 9 meg IF board.
> Board # A4
> Sub assembly #  81910
>
> 73, KI4JPL
> John Henry
> TenTec Engineering
>
>
> Could  someone please tell me on which board the hardware noise blanker
> is located  in the Orion I?
>
> Thank you.
>
> Bill  AD8P
> _______________________________________________
> TenTec mailing  list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>