As much as it will allow you! Mine makes only about 16 Watts carrier if
there is no audio. However, there is an interesting feature in the Orions
where the carrier power actually increases as modulation increases, so the
practical result is that you can get 100 Watts PEP, and 25 Watts carrier,
but only for a few seconds, then it cuts down the power when stop talking.
At any rate, the finals are rated for a lot more power than that, so it's
safe any any level.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: <kc9cdt@aol.com>
To: <ronc@sonic.net>; <tentec@contesting.com>
Sent: Monday, February 21, 2011 1:12 PM
Subject: Re: [TenTec] Orion II transmit equalization
> How much power can we run on the OII safely in AM mode?
> Thanks,
> Lee
>
>
>
> -----Original Message-----
> From: Ron Castro <ronc@sonic.net>
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Sent: Mon, Feb 21, 2011 3:34 pm
> Subject: Re: [TenTec] Orion II transmit equalization
>
>
> There is a distinct difference in the monitor sound of AM vs. SSB that I
> have noted for some time on the "Fix List" on my website. It sounds more
> like the sample rates are different with AM getting the short-changed by a
> few dozen kbps! I could be wrong about that, but they do sound different.
> The good news is that the actual on-air AM audio is fabulous and is better
> than some AM broadcast stations I have heard.
>
> Ron Castro
> N6IE
> www.N6IE.com
>
> ----- Original Message -----
> From: <Rsoifer@aol.com>
> To: <jhenry@tentec.com>; <tentec@contesting.com>
> Sent: Monday, February 21, 2011 11:31 AM
> Subject: Re: [TenTec] Orion II transmit equalization
>
>
>> John,
>>
>> Further to my earlier email, I ran some more tests, listening to
> myself on
>> an external receiver (actually, an Argonaut V). The difference in
>> equalization between AM and SSB did not show up there; both sounded
> fine
>> with TX
>> EQ set to 0 dB. However, the difference was still there on the
> Orion
>> II's
>> internal monitor, with AM sounding more bassy than SSB by about 7
> dB.
>> So,
>> it seems to be a monitor issue rather than a TX EQ issue. I don't
>> understand how and why that would happen, but there it is.
>>
>> 73 Ray W2RS
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|