Most L/C vfo's are adjusted at the low frequency end by the inductance (L) and
at the high
end by the capacitance (C). There is usually some interaction so you have to
repeat the
adjustment several times until satisfied.
73,
-Lee-
WA3FIY
On 22 Mar 2011 at 19:25, BUDW2GLN@aol.com wrote:
> I am working on a model 200 VFO.....I have installed new dial and band
> change cords....WHEW :-) and am in the process of trying to
> calibrate the master oscillator so that the unit will track end to
> end reasonably accurately...........
>
> I have the 200 instructions with print but do not have any other
> information at my disposal
>
> If anyone has a 200 and has attempted to do the accuracy alignment, I
> would
> appreciate some help. I just can't get it to track.......L1 and C1
> are
> used to accomplish this but I'm not sure which is for which end ???
>
> Thanks
>
>
> Bud, W2GLN
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|