TenTec
[Top] [All Lists]

[TenTec] Fw: TenTec Transmit Power Inputs

To: <tentec@contesting.com>
Subject: [TenTec] Fw: TenTec Transmit Power Inputs
From: "ROD" <w3krq@dejazzd.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 6 Apr 2011 10:38:46 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>

-----Original Message----- 
From: ROD
Sent: Tuesday, April 05, 2011 11:56 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] TenTec Transmit Power Inputs

John on a future update you could change the Eagle s and swr  indicator the
same as the Jupiter to  give us a choice of swr or output.  73 Rod

-----Original Message----- 
From: Henry, John
Sent: Tuesday, April 05, 2011 10:54 AM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] TenTec Transmit Power Inputs

Thought I would voice in a few comments on TenTec rigs, transmit
power, testing of such, and of course, TenTec service.

TenTec tests the transmit output power on every rig at different test
stations.
One station is where we calibrate each rig to generate 100 watts on
all bands. This test station is calibrated periodically with a
calibrated Bird. This calibrated slug, meter, and cable are used to
ensure that several of the test stations in engineering, service, and
the factory all are measuring properly.
The next station is the burn in rack where each rig is put into
various transmit power level tests for various periods of time.
The last station is the final air check where each rig has several
items air checked including power output.

There are several pieces of information that should be known.
Almost every TenTec rig has a way that it's transmit output power can
be adjusted. Some rigs have a way to adjust each band. If the
adjustment is small, then there is usually no problem in doing so. If
the adjustment is not small, then this may point to another issue in
the rig.
Do a master reset, as stated in the manual. If the power is still off,
then please contact the service department.
When performing "transmit power measurements", be sure to perform the
measurement using a good set of cables, a calibrated wattmeter, and a
known good 50 ohm dummy load.

If someone has a specific TenTec rig that is not functioning as per
the rig's published specs, then please contact TenTec service and
discuss this issue with them. They are more than willing to help
analyze the low transmit power situation with you. Sometimes it is
something that they can help you adjust over the phone, either in the
station or on the rig itself, and sometimes it is a component that
needs replacement or adjustment at the factory. Either way, TenTec
stands behind their products, and are here to help you enjoy your
hobby.

Thanks,
John Henry
TenTec Engineering
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Fw: TenTec Transmit Power Inputs, ROD <=