TenTec
[Top] [All Lists]

Re: [TenTec] Corsair - blank LED segments

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Corsair - blank LED segments
From: "CSM\(r\) Gary Huber" <glhuber@msn.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 7 Apr 2011 20:53:51 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I had a lot of display problems during the years my Corsair II was not used 
much. After re-capping the display board back in the late nineties and using 
the Corsair II as my PSK-31 radio almost daily for past ten years, I have 
not had the problem. Maybe C6 needs power on it. Replace it and use the 
Corsair II, its still a great radio!


73 es DX,

Gary - AB9M

-----Original Message----- 
From: Don Rasmussen
Sent: Thursday, April 07, 2011 8:17 PM
To: tentec@contesting.com
Subject: [TenTec] Corsair - blank LED segments

There are so many caps just like C6 in the Corsair II, yet it seems to be a 
universal culprit. Wondering if there is some reason why that specific part 
is being abnormally stressed?

=====================================

And you jiggled the connections. No doubt C6 is highly suspect and cause
of many display problems. It probably should be replaced before it goes
completely bad to save on future failures.

73, Jerry, K0CQ




_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>