I remember those. I am going to flip the radio upside-down and see what I
put in there. Perhaps I don't have the
gain jumpers correct, or perhaps I have a bum filter!!
.....Dave
----- Original Message -----
From: "Greg S" <oldlongbeard@yahoo.com>
To: <tentec@contesting.com>
Sent: Tuesday, April 19, 2011 4:33 PM
Subject: Re: [TenTec] OMNI VI+ filter anomaly
Dave- page 1-3 in the manual shows how to set the "gain jumpers"... are
they set correctly for the filters you have installed?
73-
Greg Schippers, KC8HXO
On Tue Apr 19th, 2011 3:47 PM EDT Dave Edwards wrote:
Anyone have tight CW filters in their Omni VI+ ??
I'd have to pop the bottom cover to see exactly what I have, but I know I
loaded it up with
tight CW options.
If I listen to a S9 +10db signal on 250hz, and press F1, the signal
strength stays the same.
If however, I press F2, the signal drops to about S5.
Could there be a mistake in the insertion of the filter, or what might I
check If I flip it over and look inside there?
Thanks for any thoughts on this.
.....Dave
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|