Thanks, Carl. Someone said that the Steppir Control Box would poll the
Orion if setup correctly. I plan to continue to use your Software - it
works perfectly with the every-2-second poll, but there may be times when I
want to use the Orion and Steppir independent of a computer. Got a call
into Steppir Tech Control.
Dave WN5V
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Carl Moreschi
Sent: Thursday, April 21, 2011 10:07 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Frequency output from Orion 2 via Cat Port
No you are not missing anything. The Orion must be polled to get its
frequency.
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com
On 4/21/2011 9:23 AM, David W LeJeune wrote:
> Finally got around to hooking up my Orion 2 to my Steppir controller.
Works
> great with N4PY software. However, I can find no options in the Orion 2
> menus to have the Orion output frequency/mode/etc to the CAT port whenever
> frequency, mode or other status changes occur independent of any external
> software program. I know the OMNI VI+ had this menu option.
>
>
>
> The N4PY software polls the Orion 2 at 2 second intervals whenever the
> Steppir box is checked in the N4PY setup so the Steppir gets frequency
info
> via a 'Y' cable. But without the N4PY software (or I suppose any other
> logging or control software) but without it looks you are out of luck
> attempting to control the Steppir. Am I missing something in the Orion
> setup?
>
>
>
> Dave WN5V
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|