Using the TT software from the TT down load site. Computer is xp with sp-3
and 4 gig of ram. Software loads fine on computer. Using a usb to serial
cable,which on the device controller says its in place and working fine and is
set on com 3. I went into the TT software and changed from com1 to com3 .
turned on the Pegasus and started the software the two could not communicate
with each other. tried all 6 different com port settings ,nothing changes. re
loaded the TT software ,no change. What about the Baud rate and priority
stuff,make a difference? could find no where the TT requirements for rates etc.
I just got this Pegasus, was told it worked fine ...don't they all say
that... I will buy the N4PY software as soon as I make sure the basic Pegasus
is working ok. But need to get it up and on line with what I have.
Maybe the usb/serial cable a bad thing??
can put a serial card in if needed .
Sure would be grateful for any help on this. After using a flex 5000 and power
sdr for 4 years,thought the little Pegasus would be a no brainier.
Thanks
dale wt4t
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|