I also had about two S units loss on an Omni VI+ when switching in the 9 MHz
IF
500 Hz crystal filter. The problem was traced to a bad crystal in the
filter where
re-soldering would not fix the problem. So the filter was modified to be a
7 pole
instead of an 8 pole filter. It works fine now and the filter loss
amplifier in the
9 MHz filter board exactly compensates for the filter loss when the 500 Hz
filter
is switched in.
Dave
K8AX
----- Original Message -----
From: "Bill Acito W1PA" <w1pa@hotmail.com>
To: <TenTec@contesting.com>
Sent: Thursday, June 30, 2011 10:13 AM
Subject: Re: [TenTec] Ten Tec Omni D Intermittent Receive Problem
>I had this happen on an Omni VI+, and I found a “bad pin” on a filter.
> Looked as though some contaminant had been there when the pin was
> soldered to the filter PCB, and it had not “wetted” well...
> the pin/solder contact had “fractured”...
> simply re-wetting it with a soldering iron fixed it.
>
> Bill
> W1PA
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|