| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] power went out |
| From: | Richards <jruing@ameritech.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 21 Aug 2011 01:35:04 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
OK... rookie question... how do you do that? Is it just a continuity check, or are you doing something else ? If something else, could you please explain what settings I need on my little meter? I am slowly learning what all these things do. ------------------ Happy Trails. ======================= Richards / K8JHR ========================= On 8/20/2011 16:12, Jerry Haigwood wrote: > Verify the fuses with an ohm meter. ================================================================= _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] power went out, John Molenda |
|---|---|
| Next by Date: | Re: [TenTec] power went out, Jerry Haigwood |
| Previous by Thread: | Re: [TenTec] power went out, John Molenda |
| Next by Thread: | Re: [TenTec] power went out, Jerry Haigwood |
| Indexes: | [Date] [Thread] [Top] [All Lists] |