No, Bill
Now that you mention them, we beat them around the bush too before Bob came
to the rescue from MM0-land.
The allelectronics are not the same, but, as explained, that product will do
the job.
Kris KM2KM
Merschrod
123 Warren Road
Ithaca, NY 14850
www.merschrod.net
----- Original Message -----
From: "Bill Harris" <w7kxb@msn.com>
To: <waltk8cv4612amos@att.net>; <tentec@contesting.com>
Sent: Tuesday, September 06, 2011 1:38 PM
Subject: [TenTec] TT 535/536 Back lighting
Walt:Are these the strips you are referring too?
http://www.allelectronics.com/make-a-store/category/213/Electroluminescent-Strips/1.html
LaterBillHarris-w7kxb
From: waltk8cv4612amos@att.net> To: tentec@contesting.com> Date: Tue, 6
Sep 2011 01:10:24 -0400> Subject: Re: [TenTec] 536 Delta II; Lights out.>
> I got a new strip of that illuminating stuff from All Electronics. You
have > to drop the front panel down on the bottom screws and remove the
top screws. > Unsolder the wires to the slide in back light. Cut the new
piece to match > and use clear fingernail polish to seal the cut end,
after that dries slide > it in and re-solder the wires to it. The back
light thing turns green with > 90 some volts from a little internal power
supply and looks like new.> > Walt K8CV Royal Oak, MI.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|