On Thu, Sep 29, 2011 at 2:33 PM, Glenn <wa4aos@aol.com> wrote:
> I meant to comment on the Ten Tec O6 audio you mentioned.
> I too ran a remote a pre DSPaudio line to the rear panel on one of my O6.
> I fed that into a combo preamp/amp I designed using a 6CW4 nuvistor as a pre
> amp stage, to drive
> a 6SN7/ 2A3 single ended amp stage... Ahhhhhh such sweet audio for listening
> to SSB; the wider INRAD filters helped as well.
> I simply turn up the front panel audio gain to re-gain DSP/ notch
> functionality.
> I ended up making a mini TR switch internally mounted so that default mode
> uses the DSP path and once the reed relays are
> energized, the audio was redirected to the rear panel.
Glenn, the key to success with tapping the audio pre-dsp is to add
some analog low pass filtering with a turn-over freq in the
3000-3500hz region and fairly steep roll off. The Omni 6 is just TOO
hissy/noisy if you don't do this.
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|