[TenTec] Argosy--low power problem

[Scott Sheppard <scottsheppard@videotron.ca>]

I have been doing some work on my Argosy and would appreciate anyones help on 
increasing the power output...the issue seems to be more on the low power side 
than when teh PA is switched on (its a low/hi power setting on back up to 50 
w)...I have gone thru and adjusted the bias for the low level and PA--all to 
spec

my out puts are as follow

           low setting        high setting

80        1w                        45w

40        3 w                       50w

30        2.5 w                    50w

20        2.5w                    20w

15        1w                        25w

Not the end of the worss but i would like to run it in the low switched 
position with about 4 or so watts if possible. Appreciate any tips others may 
have.

cheers

scott va3ied
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec