TenTec
[Top] [All Lists]

Re: [TenTec] Argosy--low power problem

To: Scott Sheppard <scottsheppard@videotron.ca>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Argosy--low power problem
From: wa3fiy@radioadv.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 25 Oct 2011 18:45:36 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Argosy or Argosy II?   BIG difference.

-Lee-


> I have been doing some work on my Argosy and would appreciate anyones help on 
> increasing the power output...the issue seems to be more on the low power 
> side than when teh PA is switched on (its a low/hi power setting on back up 
> to 50 w)...I have gone thru and adjusted the bias for the low level and 
> PA--all to spec
> 
> my out puts are as follow
> 
>            low setting        high setting
> 
> 80        1w                        45w
> 
> 40        3 w                       50w
> 
> 30        2.5 w                    50w
> 
> 20        2.5w                    20w
> 
> 15        1w                        25w
> 
> Not the end of the worss but i would like to run it in the low switched 
> position with about 4 or so watts if possible. Appreciate any tips others may 
> have.
> 
> cheers
> 
> scott va3ied
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>