TenTec
[Top] [All Lists]

Re: [TenTec] Orion 2 query L/S on 2nd receiver.

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion 2 query L/S on 2nd receiver.
From: "Dave G3RXP" <g3rxp@btinternet.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 9 Nov 2011 13:55:10 -0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Hi Guys,

As soon as you connect headphones to the front socket the loudspeakers 
inside and external speaker is disabled so it doesnt matter how you 
configure the audio controls I cannot get them to all work at the same time.

  I agree on the RF control, and this is always the way I have run a RX 
whatever the type -but the trouble is that the S meter doesnt work.

Dave



----- Original Message ----- 
From: "Mark van Wijk" <pa5mw@home.nl>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Cc: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, November 09, 2011 11:09 AM
Subject: Re: [TenTec] Orion 2 query L/S on 2nd receiver.


> One more thing.......
>
> Never use any outboard (DSP) processor for the audio. The greatest asset 
> of the ORION is its ability of a wonderfull recovered audio presentation.
>
> Use your RF Gain, never set it above 90. Ever. Not even on 10/12mtrs.
>
> So, .....actually two :)
>
> 73, Mark,PA5MW
>
>
> On 9 nov. 2011, at 11:29, Dave G3RXP <g3rxp@btinternet.com> wrote:
>
>> Hi Barry and Mark thanks for the info - I think the internal L/S is 
>> disabled
>> when the external L/S is plugged in, the same with headphones - but Ill
>> check those suggestions again.
>> Just thinking about it I have my headphones connected to the back exp L/S
>> via an external DSB audio filter so that may be the problem.
>>
>>
>> Thanks  Dave
>>
>> ----- Original Message ----- 
>> From: "Barry N1EU" <barry.n1eu@gmail.com>
>> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
>> Sent: Wednesday, November 09, 2011 9:28 AM
>> Subject: Re: [TenTec] Orion 2 query L/S on 2nd receiver.
>>
>>
>>> On Wed, Nov 9, 2011 at 9:18 AM, Dave G3RXP <g3rxp@btinternet.com> wrote:
>>>
>>>> I would like to monitor the 2nd RX by loudspeaker and use the 
>>>> headphones
>>>> for the main RX and wondered what is the best method to do this. I 
>>>> could
>>>> use the line output socket at the back but I may have missed an easy
>>>> option?
>>>
>>> Why not use the EXT SPKR output on the rear panel (or just the Orion's
>>> internal speaker) with Audio configured as Left/Right=Main and
>>> Spkr=Sub?
>>>
>>> Barry N1EU
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>