I for one hate QSK..
It is very iritating to hear RX noise between chars & words.
I use good old fashioned semi_break in.
73,
Lee
-----Original Message-----
From: Richards <jruing@ameritech.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Thu, Nov 17, 2011 11:06 am
Subject: Re: [TenTec] Orion's break in
At the risk of being labeled a "lid" - is there a handy explanation of
how this QSK thing works, in practice, and how one uses it in daily
life?
I am going through a Code Course and looking to add CW to the mix...
and
I have this mental image of concentrating on sending code, and becoming
annoyed with someone trying to bust in and interrupt my flow, by keying
over me. I guess if I am calling CQ, it would help me know someone
was
returning the call, but why does he not wait until I listen for him?
Now... I am sure that is a mistaken or ignorant outlook, but I do not
know WHY not ! (I have some ideas about all this, but I would rather
trade on fact than mere supposition... you KNOW what happens when you
assume something... eh?)
I don't mind reading up if there is a good explanation, but the ARRL
Operating Handbook left me cold, and so did my license training guides.
Anybody know a source of good info on good CW operating practice, in
general, and the best use of QSK, in particular ?
=================== Anonymous - K8JHR =============================
On 11/17/2011 5:09 AM, Barry N1EU wrote:
>
> FWIW, I get about 60wpm on my Orion and still enough unmuting between
> characters to just tell that someone is on frequency.
=====================================================================
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|