Hi Scott,
That should not be happening! We will have to do some investigating to find
out why. I need to know if you have the RIT pot set up in the manner
described by W0CCA. If you do and you are sure that you are not split, then
the R voltage may not be behaving properly. Let me know about the RIT setup
and also measure the voltage on pin 38 of the processor in both Rx and Tx
modes. Report back to me and we will proceed from there.
Joe
----- Original Message -----
From: <scottsheppard@videotron.ca>
To: <tentec@contesting.com>
Sent: Sunday, November 20, 2011 8:13 PM
Subject: [TenTec] help with Corsair II tx/rx off freq issues
>I just recently picked up a lovely Corsair II (to add to the TT madness)
>and the DDS kit from N4YG,,,the difference, by the way, is amazing and
>makes the rig an even greater pleasure to use than before.
>
> Upon installing it and actually using the rig a bit, however, I note that
> my Tx and Rx freq are not aligned. Its not that the rig display may be a
> bit off but rather the station signal I am listening to is on one freq and
> when I transmit back, I am about 600hz off (as though working split--which
> I am not), I did not adjust anything else after the install but the issue
> may have been pre-existing.
>
> Seems to me I had similar issues on an older Omni A but don't recall what
> I tweeked or balanced...any thoughts from the Corsair crowd?
>
> 73
>
> scott va3ied
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|