Thanks Barry. OK on not recommending that anybody change them.
I'm curious as to how AL7CR knew that feature was there..
73 Tom AA4VV
On 12/31/2011 4:48 PM, Barry N1EU wrote:
> I've never seen a description of what those values mean. I just
> played with them until the Orion s-meter responded similarly to a
> known good receiver's s-meter. I can't really recommend that anybody
> else changes those values.
>
> Barry N1EU
>
> On Sat, Dec 31, 2011 at 9:17 PM, Tom Berry<tberry1@triad.rr.com> wrote:
>> Let me see if I understand this function. I would select an S meter
>> value (say S9) then change the digital count so that the S meter reads
>> S9. Is that correct?
>>
>> 73 Tom AA4VV
>>
>>
>>
>> On 12/31/2011 3:48 PM, Barry N1EU wrote:
>>> Thanks - it's uncharted territory in there but I think I managed to
>>> improve things. I was careful to record the original values before
>>> mucking around.
>>>
>>> 73, Barry N1EU
>>>
>>> On Sat, Dec 31, 2011 at 7:18 PM, AL7CR<al7cr@punakea.com> wrote:
>>>> Go to the RX menu and press the 15m band select key. This will bring up
>>>> a screen that allows you set the S meter in digital counts.
>>>>
>>>> AL7CR
>>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|