TenTec
[Top] [All Lists]

Re: [TenTec] Re. [Ten Tec] Grounds

To: tentec@contesting.com
Subject: Re: [TenTec] Re. [Ten Tec] Grounds
From: Stuart Rohre <rohre@arlut.utexas.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 25 Jan 2012 14:30:22 -0600
List-post: <mailto:tentec@contesting.com>
Wade probably has some critical resonant length of feedline that feeds RF back to this station from the antennas when his good earth bonds are not connected.

In this case, he has done a good job of earthing his station. The only improvement any ham can make is to always use copper ribbon in place of round wires, to have lower inductance in that ground lead.

Usually, a feedline should not be a quarter wave odd multiple in length at any band you use. Use of a balanced antenna tuner with open wire feeders is best, but you can use a high quality line choke or 1:1 balun in many cases, and 4:1 in other cases. Sometimes, you have to try it out to find the best balun set up.

-Stuart Rohre
K5KVH

<Prev in Thread] Current Thread [Next in Thread>