To: | tentec@contesting.com |
---|---|
Subject: | [TenTec] OMNI D ser B low power output--still no joy |
From: | scottsheppard@videotron.ca |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Tue, 14 Feb 2012 18:10:16 -0500 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Actually, I really have next to no output when I bypass the PA...the two watts I get is when the PA is in line...possibly it is only getting 200mW and the PA is bringing it up to 2 watts (?)...Paul from Ten-Tec sent me a msg indicating that I should check the t-R voltages on the control board as well as the diodes in the swr bridge...When I get back home this week I will give this a go. I will let you know how I make out...again, many thanks for the assistance folks. scott va3ied _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Omni VI and Bux Com, Jim Carragher |
---|---|
Next by Date: | [TenTec] FS: Eagle including autotuner, noise blanker, filters, $1, 400, Jeff |
Previous by Thread: | Re: [TenTec] OMNI D ser B low power output--still no joy, Rick - DJ0IP / NJ0IP |
Next by Thread: | [TenTec] RX366 IF output and roofing filters, Zivney, Terry |
Indexes: | [Date] [Thread] [Top] [All Lists] |